Reference : Effects of the roll forming process on the mechanical properties of thin-walled sections...
Scientific congresses and symposiums : Paper published in a book
Engineering, computing & technology : Mechanical engineering
Engineering, computing & technology : Materials science & engineering
Effects of the roll forming process on the mechanical properties of thin-walled sections made of non linear metallic materials
Rossi, Barbara mailto [Université de Liège - ULg > Département Argenco : Secteur MS2F > Adéquat. struct. aux exig. de fonct.& perfor. techn.-écon. >]
Boman, Romain mailto [Université de Liège - ULg > Département d'aérospatiale et mécanique > LTAS-Mécanique numérique non linéaire >]
Degée, Hervé mailto [Université de Liège - ULg > Département ArGEnCo > Département ArGEnCo >]
Proceedings of the 6th International Conference on Thin Walled Structures: ICTWS2011, Timisoara 5-7 September 2011
The 6th International Conference on Thin Walled Structures: ICTWS2011
from 5-09-2011 to 7-09-2011
[en] cold roll forming
[en] It is well known that the cold-forming process is likely to significantly enhance the
mechanical properties of the profile by strain hardening leading to increased resistance compared to a resistance assessment based on nominal properties. It is thus necessary to accurately determine the mechanical properties after the cold process of fabrication. The knowledge on these enhanced properties is rather good for profiles made of traditional construction steel (carbon steel with yield strength between 200 and 400 MPa) characterized by an elasticplastic behaviour. However less information is available for profiles made of materials exhibiting a non linear stress-strain relationship. In this context, the paper presents a parametric study on roll-profiled channel sections. For that purpose, the finite element code METAFOR developed at the LTAS division of the University of Liège is used to simulate the forming process of profiles made of high strength steel and of stainless steel. In the simulations, different values of the radius to thickness ratio of the corners are considered. The results of the
numerical simulations are expressed in terms of resulting proof strength in the corners versus
the radius to thickness ratio for the different materials. They are finally compared to existing
predictive formulations. Additional considerations are also given on the forming process itself
(i.e. on the configuration of the rolls or on the springback).
Researchers ; Professionals ; Students

File(s) associated to this reference

Fulltext file(s):

Restricted access
ICTWS2011_11BY_Full_paper.pdfAuthor preprint619.78 kBRequest copy

Bookmark and Share SFX Query

All documents in ORBi are protected by a user license.