References of "Libert, Lionel"
     in
Bookmark and Share    
Full Text
See detailDosimetry for 6-[18F]Fluoro-L-DOPA in humans based on in vivo microPET scans and ex vivo tissue distribution in mice
Bretin, Florian ULg; Warnock, Geoffrey ULg; Bahri, Mohamed Ali ULg et al

Poster (2012, September)

Radiation dosimetry of new radiopharmaceuticals generally starts with studies in small animals such as mice and rats. The traditional technique has long been ex vivo measurement of the biodistribution ... [more ▼]

Radiation dosimetry of new radiopharmaceuticals generally starts with studies in small animals such as mice and rats. The traditional technique has long been ex vivo measurement of the biodistribution over time using harvested organs at different times post administration of the radiopharmaceutical. Since this approach requires a significant amount of animals, dynamic microPET studies, where the biodistribution of the tracer over time can be determined in vivo in a single scan, are an invaluable alternative. Due to known imaging artifacts and limitations, such as partial volume effect, a hybrid technique combining harvesting organs (post-scan) and dynamic imaging was introduced to achieve a cross-calibration to account for these limitations. Since 6-[18F]Fluoro-L-DOPA is a widely used PET tracer to study the dopaminergic system in neurology and oncology and there is no sound published dosimetry data, absorbed doses for major organs in humans were estimated using the traditional ex vivo technique and by dynamic microPET imaging in mice, allowing direct comparison of the results from the two techniques. The tissue distribution over time of 6-[18F]Fluoro-L-DOPA was determined by radioassay of harvested organs at 2, 5, 10, 30, 60, 120 minutes post administration (n=5 at each time point) in isoflurane-anaesthetized mice. Dynamic PET images were acquired with a FOCUS 120 microPET for 120 minutes after injection of 6-[18F]Fluoro-L-DOPA followed by radioassay of harvested organs (n=4). A bladder voiding scenario was used to simulate excretion every 2 h. The organ time-activity-curves (TACs) from both methods were extrapolated from a simulated 35 g standard mouse to a 70 kg standard male human using a technique based on organ to bodyweight ratios. The absorbed doses in major human organs were calculated with the commercially available human dosimetry software OLINDA/EXM (Version 1.1) using the extrapolated TACs. The extrapolated organ TACs obtained using the two methods showed a high correlation (average r = 0.94 ± 0.05, p < 0.001). However, TACs from PET alone under- or overestimated the activity in individual organs in contrast to TACs obtained using the cross-calibration of the PET data with the activity in post-scan dissected organs. Those organs in the excretion pathways, comprising bladder wall, kidneys and liver, received the highest organ doses. The total body absorbed dose was 0.0118 mGy/MBq for both the imaging based and harvesting based methods. The effective dose was 0.0193 mSv/MBq for the hybrid imaging-harvesting technique and 0.0189 mSv/MBq for the pure harvesting technique. Scaling errors in the PET TACs are likely caused by quantification errors such as partial volume effects and image artifacts. The use of a hybrid imaging technique to cross-calibrate the TACs improved the accuracy of the imaging-based dosimetry estimates. Therefore the hybrid technique combining dynamic imaging and harvesting organs (post-scan) is a suitable alternative to the gold standard ex vivo radioassay method. It yields comparable results yet reduces significantly the amount of animals needed in the study and can accelerate data acquisition. [less ▲]

Detailed reference viewed: 43 (8 ULg)
Full Text
See detailFast Production of Highly Reactive No-Carrier-Added [18F]Fluoride for the Labeling of Radiopharmaceuticals
Lemaire, Christian ULg; Aerts, Joël ULg; Voccia, Samuel et al

in Angewandte Chemie (International ed. in English) (2010), 49

The 18F labeling of radiopharmaceuticals requires nearly anhydrous solutions of [18F]fluoride. Aqueous K2CO3 is generally used to elute [18F]fluoride from an anion-exchange resin. Replacing aqueous K2CO3 ... [more ▼]

The 18F labeling of radiopharmaceuticals requires nearly anhydrous solutions of [18F]fluoride. Aqueous K2CO3 is generally used to elute [18F]fluoride from an anion-exchange resin. Replacing aqueous K2CO3 with strong organic bases, such as the phosphazene base P2Et enabled the recovery of highly reactive [18F]fluoride and avoided the azeotropic evaporation of water, which is very difficult on a microchip device. [less ▲]

Detailed reference viewed: 95 (33 ULg)
Full Text
See detailNew Improvements in the Enantioselective Synthesis of 2-[18F]Fluoro-L-Tyrosine and 6-[18F]Fluoro-L-Dopa
Libert, Lionel ULg; Lemaire, Christian ULg; Denoël, Thibaut ULg et al

in Journal of Labelled Compounds & Radiopharmaceuticals (2009, July), 52(S1), 196

Detailed reference viewed: 35 (13 ULg)
Full Text
See detailLarge Scale Preparation of [18]Fluoromethoxybenzyl Bromides, Key Precursors for 2-[18F]Fluoro-L-Tyrosine and 6-[18F]Fluoro-L-Dopa
Libert, Lionel ULg; Lemaire, Christian ULg; Wouters, Ludovic ULg et al

in Journal of Labelled Compounds & Radiopharmaceuticals (2009, July), 52(S1), 292

Detailed reference viewed: 50 (7 ULg)
Full Text
See detailFast and Reliable Method for the Preparation of Various [18F]Fluorobenzyl Halides
Lemaire, Christian ULg; Libert, Lionel ULg; Plenevaux, Alain ULg et al

in Journal of Labelled Compounds & Radiopharmaceuticals (2009, July), 52(S1), 178

Detailed reference viewed: 22 (7 ULg)
Full Text
See detailMicrowave-Assisted Synthesis of Vinyl Esters through Ruthenium-Catalyzed Addition of Carboxylic Acids to Alkynes
Nicks, Francois ULg; Libert, Lionel ULg; Delaude, Lionel ULg et al

in Australian Journal of Chemistry (2009), 62(3), 227-231

A rapid and efficient method is described for the selective synthesis of enol esters via the microwave-accelerated addition of carboxylic acids to terminal alkynes. The method employs the readily ... [more ▼]

A rapid and efficient method is described for the selective synthesis of enol esters via the microwave-accelerated addition of carboxylic acids to terminal alkynes. The method employs the readily available [RuCl2(p-cymene)(PPh3)] complex as catalyst without the need of bases, and reactions are complete in 20 min. [less ▲]

Detailed reference viewed: 45 (23 ULg)
Full Text
See detailMicrowave-assisted synthesis of vinyl esters through ruthenium-catalyzed addition of carboxylic acids to alkynes
Nicks, Francois ULg; Libert, Lionel ULg; Delaude, Lionel ULg et al

in Polymer Preprints (2008), 49(2), 944-945

1-Hexen-2-yl 4-acetoxybenzoate was regioselectively prepd. via microwave-assisted ruthenium-catalyzed addn. of 4-acetoxybenzoic acid to 1-hexyne. Species of catalysts, reaction time and temp. play roles ... [more ▼]

1-Hexen-2-yl 4-acetoxybenzoate was regioselectively prepd. via microwave-assisted ruthenium-catalyzed addn. of 4-acetoxybenzoic acid to 1-hexyne. Species of catalysts, reaction time and temp. play roles in the reaction respect to yields and selectivity, therefore were examd. Microwave effect was obsd. and preferred to the generation of the Markovnikov-type product compared to traditional heating. [less ▲]

Detailed reference viewed: 36 (7 ULg)